纳米级TiO2粉体的制备研究——Ⅱ.絮凝剂及其浓度的影响

采用溶胶-凝胶-超临界流体干燥(SCFD)法制备纳米级TiO₂超细粉，详细考察了不同絮凝剂及其浓度对TiO₂织构和结构性质的影响。结果表明，利用强碱溶液作为絮凝剂，浓度为5 mol·L^-1是制备大孔高比表面TiO₂超细粉较为适宜的条件。     

Untersuchungen im System LaI2/H2: Phasenverhältnisse und Fehlordnung

Investigation of the LaI₂/H₂ System: Phase Relations and Stacking Disorder Heating of LaI₂ under 1 bar hydrogen pressure to 650 °C leads to light gray LaI₂H_0.95(3), accompanied by a structural change from tetragonal to hexagonal. Sharp reflections in the XRD pattern can be indexed in P6₃/mmc with a = 4.2158(7)Å and c = 15.508(3)Å, however, diffuse reflections indicate the presence of stacking faults in the structure, which correspond to a polytypic intergrowth of MoS₂ and NbS₂ type structural fragments. Increasing the reaction temperature to 730 °C results in a better defined diffraction pattern with the peak positions close to those of the 2H‐NbS₂ structure type. An X‐ray powder study of the samples LaI₂H_n proved the miscibility gap between LaI₂ and LaI₂H_n (0 ≤ n ≤ 0.5) in agreement with previous results. With decreasing H‐content of the homogeneous phase the lattice parameters change in opposite direction, a increasing to 4.236(1)Å and c decreasing to 15.39(2)Å for the lower limit.     

固固相反应合成牛磺酸水杨醛钾与锑、铋的配合物

合成了牛磺酸水杨醛钾,并采用室温固固相反应法合成了牛磺酸水杨醛钾与三氯化锑和三氯化铋的配合物,其组成为:K2MC18H20O8N2S2 (M = Sb, Bi)。两种配合物的晶体结构均属于单斜晶系,锑配合物的晶胞参数为:a = 1.2869 nm, b = 1.7636 nm, c = 1.9917 nm, β= 93.79埃活榕浜衔锏木О问篴 = 1.4770 nm, b = 2.0334 nm, c = 2.0149 nm, β= 94.05。红外光谱表明N、Cl原子参与了配位,中心离子的配位数为5。     

Magnesium substitution in Nd0.7Sr0.3MnO3

Magnesium substitution in Nd_0.7Sr_0.3MnO₃ has been studied by neutron powder diffraction. Polycrystalline samples of nominal compositions Nd_0.7Sr_0.3Mn_1−yMg_yO₃ with y=0.0, 0.1, 0.2 and 0.3 were synthesized by the standard solid-state reaction method. Rietveld refinements of the neutron powder diffraction data showed that all samples had distorted perovskite structure of orthorhombic symmetry. Mg initially preferred to substitute for Nd and only at Mg concentration greater than 0.1, a substantial substitution for Mn occurred. Our study also showed that Mg-substitution did not change the crystal structure of Nd_0.7Sr_0.3MnO₃.     

Crystal structures and phase transition in the system SrTiO3-La2/3TiO3

The distribution of A-site cations in the perovskite system La_xSr_1−3x/2TiO₃ depends on the concentration of La³⁺ ions and associated vacancies. For small x (x?0.2), the substitutions are expected to be random. For x?0.55, the cations are ordered in such a way that successive layers of A-sites are occupied to greater and lesser degree, and this ordering drives a tetragonal distortion. For x from about 0.3 to 0.5, the X-ray patterns show diffuse peaks indicative of similar ordering, but this is not long-range order and no tetragonal distortion results. The lower temperature structures also exhibit out-of-phase tilting of the TiO₆ octahedra, setting in at temperatures varying linearly with composition from 105 K for x=0, to about 650 K at x=2/3.     

Chemical, sensory and microbiological changes of gamma irradiated coconut cream powder

A study was carried out to determine optimum decontamination dose for a locally manufactured coconut cream powder. Samples were gamma irradiated (0–15 kGy) and ageing process was achieved using GEER oven at 60 °C for 7 days, which is equivalent to one-year storage at room temperature. Iodine value (IV), ranging from 4.8 to 6.4, was not affected by radiation doses and storage, however peroxide value and thiobarbituric acid (TBA) generally increased with radiation doses. In most samples, peroxide value (meq/kg) reduced after storage, whilst the TBA (mg malonaldehyde/kg), indicator for product quality, slightly increased. The sensory evaluation conducted using 25 taste panellists indicated that scores on odour, creamy taste and overall acceptance for all irradiated samples at more than 5 kGy were significantly lower (P<0.05) than the control. However, the panellists could not detect any significant differences among the irradiation doses (P>0.05). All stored products were significantly different in colour, creamy taste, odour and overall acceptance (P<0.05) when compared to the non-stored non-irradiated control. Microbiological count of the samples prior to irradiation was in the range of 1×10²–1.7×10³ cfu/g with no detection of Salmonella sp. and Escherichia coli. No microbial colonies were detected after irradiation. Based on the TBA and overall sensory acceptance, gamma irradiation of 5 kGy was found to be the optimum dose and lower doses can be considered to decontaminate coconut cream powder.     

不同剂型药用抑肽酶纯度的胶束电动毛细管测定

 以十六烷基三甲基溴化铵 (CTAB)为阳离子表面活性剂 ,用胶束电动毛细管 (MECC)分别对抑肽酶粉针剂和抑肽酶注射液进行纯度测定。实验中选择了最佳缓冲液 (含 4mmol/LCTAB的 80mmol/LNa2 HPO4 H3 PO4,pH 7 0 0 ) ,考察了进样量与样品中高浓度盐对分离的影响。并对毛细管区带电泳、MECC和高效液相的分离效果加以比较 ,表明MECC的分离效果最佳。     

A Structural Investigation of La2(GeO4)O and Alkaline-Earth-Doped La9.33(GeO4)6O2

The structures of the oxyorthogermanate La₂(GeO₄)O and the apatite-structured La_9.33(GeO₄)₆O₂ have been refined from powder neutron diffraction data. La₂(GeO₄)O crystallizes in a monoclinic unit cell (P2₁/c) and is cation stoichiometric in contrast to previous reports. La_9.33(GeO₄)₆O₂ crystallizes in a hexagonal unit cell (P6₃/m) and the powder diffraction data show anisotropic peak broadening that is observed in electron diffraction patterns as incommensurate diffuse spots at hkq reciprocal planes (with q=1.6-1.7) and can be attributed to a correlated disorder in the “apatite channels”. This compound was doped up to a nominal composition close to M₂La₈(GeO₄)₆O₂ with M=Ca, Sr, Ba. The dopant ions preferentially occupy the 4f sites as the number of La vacancies decreases. The measured ionic conductivity of La_9.33(GeO₄)₆O₂ is about 3 orders of magnitude larger than for La₂(GeO₄)O at high temperatures and decreases with increasing dopant content from the highest value of about 0.16 S cm⁻¹ at 1160 K.     

A novel zirconocene/ultradispersed diamond black powder supported catalytic system for ethylene polymerization

A novel carrier of ultradispersed diamond black powder (UDDBP) was used to support metallocene catalyst. Al₂O₃ was also used as carrier in order to compare with UDDBP. Supported catalysts for ethylene polymerization were synthesized by two different reaction methods. One way was direct immobilization of the metallocene on the support, the other was adsorption of MAO onto the support followed by addition of the metallocene. Four supported catalysts Cp₂ZrCl₂/UDDBP, Cp₂ZrCl₂/Al₂O₃, Cp₂ZrCl₂/MAO/UDDBP and Cp₂ZrCl₂/Al₂O₃/MAO were obtained. The content of the zirconium in the supported catalyst was determined by UV spectroscopy. The activity of the ethylene polymerization catalyzed by supported catalyst was investigated. The influence of Al/Zr molar ratio and polymerization temperature on the activity was discussed. The polymerization rate was also observed.     

CuO超细粉体的形貌与红外特性研究

CuO作为一种多功能精细无机材料，在印染、陶瓷、玻璃及医药等领域的应用已有数十年的历史，作为催化剂的主要活性成分，近年来在氧化、加氢、C１化学合成、NOx还原、CO及碳氢化合物燃烧、精细化工等多种催化反应中也得到了广泛的应用。可以推测，当CuO材料的粒度达到纳米级时，将使它的功能更加独特，应用更为广泛。因此CuO纳米材料的制备方法、聚集状态、与其他组分或载体的作用状况及催化活性等成为当前功能材料发展的研究热点之一犤１～８犦。我们在前文中报道了直接热解Cu２（OH）２CO３所得CuO粒径小、分布均匀、比表面积大，…